Hearthstone Wild Decks

Reinstall the engine belt,Hearthstone Wild Decks detailed explanation of the operation steps! The engine skin is in progress.Before installing the belt, we need to prepare some tools and materials, such as new engine belts, wrenches, jacks, air pliers, compressors, etc. After preparing these tools and materials, we can start the operation. The first step is to open the hood and remove the old belt. This step requires special care, especially when removing the tension wheel, the belt must be completely removed to avoid damage to any part of the engine due to the loss of tension. The second step is to check the tightness of each part of the engine. After checking, make sure that there are no loose parts of the whole system and make a good mark. If there are loose parts, they need to be reinstalled and tightened. The third step is to install a new belt. Before installing the new belt, it is necessary to check whether the original belt is worn or cut. This can be confirmed by reversing the belt and checking for creases and cracks.If the old belt is worn or cut, it needs to be replaced immediately. Put the new belt on the gear of the larger tension wheel, and then gradually pass through the tension wheel and other gears to ensure that the new belt is installed correctly. Next, we need to rotate the tension wheel properly until we can pass the belt through the tension wheel. In this process, pay attention to the direction of the belt and the direction of the tension wheel to ensure that the belt is installed correctly. The fourth step is to check the tension. After installing the new belt, you need to check whether the tension is correct. The correct tension can ensure that the belt will not be loose or too tight, thus prolonging the service life of the belt. When checking the tension, you need to rotate the tension wheel appropriately with a wrench and check the elasticity of the belt. If the tension is insufficient, the tension needs to be adjusted appropriately. Step 5, restart the engine and check it.We need to restart the engine and let the engine run for a period of time to ensure that the belt works normally. In this process, it is necessary to check the operation of each gear to ensure that each part is working normally. Step six, check the tightness of all parts again. After replacing the belt, it is necessary to check the tightness of the whole vehicle again. This can ensure that the belt will not slip or loosen during operation, and reduce the failure of the system caused by loose fastening. In a word, although replacing the engine belt seems simple, it is necessary to pay strict attention to various links to ensure that the belt is installed correctly and can operate normally. Through the above steps, we can easily complete the operation of reinstalling the engine belt.

Contact Us
Phone：020-83484661